mission control mac os feature for switchable desktop environments

MISSION CONTROL MAC OS FEATURE FOR SWITCHABLE DESKTOP ENVIRONMENTS SERIAL

I 2C (Inter-Integrated Circuit) Bus Technical Overview and Frequently Asked Questions – Embedded Systems Academyįigure 3 : Sample SPI Implementation.I 2C bus – NXP (Philips) Semiconductors Official I 2C website.This can be inefficient in simple configurations and a direct-link interface such as SPI might be preferred. This helps reduce the cost and complexity of the circuit as additional devices are added to the system.ĭue to the presence of only two wires, there is additional complexity in handling the overhead of addressing and acknowledgments. Since only two wires are required, I 2C is well suited for boards with many devices connected on the bus. It supports multiple data speeds: standard (100 kbps), fast (400 kbps), and high speed (3.4 Mbps) communications.įor more information about other features, see the references at the end of this section. I 2C has many features other important features worth mentioning. – Since there are only two wires, this protocol includes the extra overhead of the addressing and acknowledgement mechanisms.

When the communication is complete, the master issues a stop condition indicating that everything is done.įigure 2 shows a sample bitstream of the I 2C protocol.įigure 2 : I 2C Protocol.

The transmitter sends 8 bits of data to the receiver, which replies with a 1 bit acknowledgment. Both the master and slave can receive or transmit data depending on whether the communication is a read or write.

Communication proceeds between the master and the slave on the data bus.

The slave device with the matching address responds with an acknowledgment signal.

The master device sends the address of the target slave device and a read/write flag.

MISSION CONTROL MAC OS FEATURE FOR SWITCHABLE DESKTOP ENVIRONMENTS SERIAL

This condition informs all the slave devices to listen on the serial data line for their respective address.

The master device issues a start condition.

For precise details, please refer to the Philips I 2C specification.

Here is a simplified description of the protocol. Slave devices have a predefined address, but the lower bits of the address can be assigned to allow for multiples of the same devices on the bus. Consequently, there is additional overhead because an addressing mechanism is required for the master device to communicate with a specific slave device.īecause all communication takes place on only two wires, all devices must have a unique address to identify it on the bus.

– Regardless of how many slave units are attached to the I 2C bus, there are only two signals connected to all of them.

Mission control mac os feature for switchable desktop environments